Digital Security Controls PC1575 Instrukcja Instalacji Pobierz pdf (Strona 8)

DIAGRAM 2-1

Hook-up For PC5010, PC5015, PC1555/1565, PC1575/

1580 or PC580/585 Panels

CAUTION: Due to the sensitivity of the RF circuitry, avoid any contact with the coils

and potentiometers on the LINKS2450 circuit board.

*If power supply supervision is required for the LINKS2450 VTX terminals, use the

PC5204. If no supervision is needed, you can use the PS1520 or the control panel

Bell+/Aux- terminals.

NOTE: Programming section [01], Option 2 must be OFF for LINKS2450 to work

with these panels.

PROGRAMMING DESCRIPTIONS

Section 4

[01] Module Configuration

Option 1: Communications Enabled / Disabled

Enable this option to have the LINKS2450 initiate communications for all events that

have reporting codes and call direction options (section [30]) programmed.

Disable this option to test the system.

Option 2: Serial Connection / Keybus Connection

Enable this option if you will use the LINKS2450 with a PC4010/4020 panel. Disable

this option if you will use the LINKS2450 with a PC5015, PC5010, PC1575/1580,

PC1555/1565/1565 or PC580/585 panel.

[10] LINKS2450 Account Code

This 4-digit code is used to identify the system and is transmitted when the

LINKS2450 initiates communications. Program a 4-digit code in this section using

2 two-digit hexadecimal numbers. Refer to your control panel

Installation Manual

for instructions on programming hexadecimal digits.

NOTE: An account number must be entered in this section before the LINKS2450

can send aeny communications. Programming [FFFF] will disable the LINKS2450.

[20] Maintenance Alarms and Restoral Reporting Codes

Program 2 digit reporting codes for the following:

• Keybus/Serial Fault Alarm:

This code will be sent when connection is lost to

the panel for more than 30 seconds.

• Keybus/Serial Fault Restoral: This code will be sent when connection is

restored to the panel for more than 30 seconds.

• For Future Use.

[30] Call Direction Options (PC5015, PC5010, PC1575/1580,

PC1555/1565 and PC580/585 panels only)

Program which of the following reporting code types the LINKS2450 will send to the

central station:

• Alarm/restore reporting

• Tamper/restore reporting

• Opening/closing reporting

• System maintenance reporting

• System test transmission reporting

• Future event support

In most installations, you should program the tranmission of alarm/restore

reporting codes only. Your radio network has limited bandwidth and capacity. The

more signals each LINKS2450 transmits, the fewer LINKS2450s you will be able to

install on your network.

The Future Event Support option refers to reporting codes (events) that may be

added to future software versions of DSC control panels. If you turn on the Future

Event Support option, when the new events occur, the LINKS2450 will send

reporting codes for the events to the central station. If you do not turn this option

on, the LINKS2450 will not send reporting codes for events that are not currently

included in one of the call direction groups.