Digital Security Controls PC1575 Instrukcja Instalacji Pobierz pdf (Strona 59)

Sensor Reset

This option will activate, by partition, all outputs (Main Bell, SW Aux., PGM outputs)

that are programmed for the “Sensor Reset” option.

A window will appear to allow you to determine in which partition or partitions the

sensor reset will be activated. An arrow will indicate the selected partitions; after

selecting the partitions, select the “execute” command to download the reset

command to the control panel.

Combus Reset (PC40X0 only)

This option is used to re-initialize communications between the main panel and the

modules by removing power from the modules to reset them. Special note when

using Combus Reset on a PC4000 Control Panel only: a Combus reset will

terminate the connection between the panel and the downloading computer.

Send LCD Message

Use this option to send a message to display on the LCD keypads installed on the

premises. When selected, a window will allow you to enter a 32 character message (2

lines of 16 characters each). Type the message and press [ENTER].

On PC40X0 files, a window will allow you to determine which partition or partitions

will display the message on the LCD4500 keypads. An arrow will indicate the

selected partitions. After selecting the partitions, select the “execute” command to

download the message to the control panel. The message will be displayed on all the

keypads assigned to the designated partitions.

The message will be displayed when the partition is disarmed. The message will be

erased after the partition has been armed and disarmed three (3) times. If another

message is downloaded to the control panel, the new message will immediately replace

the first. The message is erased from Global Keypads only after all partitions to which

the message was sent have been armed and disarmed three times.

On (PC5015, PC5010, PC5008, PC1575/1580, PC1565-2P, PC1555/1565 and PC580/

585 files only) panels, the message will be displayed after 30 seconds of inactivity (i.e.

no keypresses) on each LCD keypad. The message can be cleared from the keypad

display by pressing any key. It will then re-appear after 30 seconds of inactivity on the

keypad. The message will be erased after having been cleared from the keypad the

number of times programmed in the panel. If another message is downloaded to the

control panel, the new message will immediately replace the first message.

Special Message (PC40X0 only)

This option is used to enable or disable the special message feature for each of the

partitions on the PC4020 / PC4010 / PC4000. Special messages are the two

messages the installer can program for the user. They are the Fail to Arm message

and the Alarm When Armed message.

Remote Operation (PC4020 and PC4010 Only)

This option is used to enable or disable outputs programmed for remote operation.

Reset Latching Tamper (PC5015, PC5010, PC5008, PC4020 v2.x,

PC4010 v2.x, PC1575/1580, PC1565-2P, PC1555/1565 or PC580/

585 files only)

This option is used when the system uses Double End-of-Line Resistor Zones and the

Tamper Inhibit Arming option is enabled or if the system has 24-hour Latching Zones.

Selecting “Reset Latching Tamper” will reset the tamper condition and allow the affected

partition to be armed as if installers programming had been entered from a keypad.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 109 110

Komentarze do niniejszej Instrukcji

Brak uwag

Digital Security Controls PC1575 Instrukcja Instalacji Strona 59

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Digital Security Controls PC1575